Exhibitions

Discover which trade fair, exhibition and event Progea will be partecipating on
This calendar shows the fixed dates in which Progea will be present in the forthcoming events.
Progea Srl
Via D’Annunzio 295,
I-41123 Modena (Italy)
View on map
Italia: HQ +39 059 451060
Internazionale: +41 91 9676610
Germania: +49 7721 99 838 0
USA: +1 888 305 2999
The SaiaDataMode driver has been developed to communicate with Saia-Burgess PCD series PLCs. It is a direct driver, not based on Saia libraries, making it possible to communicate in different ways:
This section cannot be accessed by “Guest” users and requires the “User” level reserved for customers who own development license. If you own a development license and have not yet been enabled at User level, please send a request email to [email protected], specifying the Serial Number of your development license and the Username to be enabled.
Movicon 11 – Rel. 11.4.1.9 DBL286
Movicon 11 CE – Rel. 11.4.1.9 DBL286
The Omron FINS Ethernet driver was designed specifically for the use with OMRON programmable controllers. This protocol connect a number of OMRON controllers over an Ethernet network.
This section cannot be accessed by “Guest” users and requires the “User” level reserved for customers who own development license. If you own a development license and have not yet been enabled at User level, please send a request email to [email protected], specifying the Serial Number of your development license and the Username to be enabled.
Movicon 11 – Rel. 11.4.1.10 DBL288
Movicon 11 CE – Rel. 11.4.1.10 DBL288
The Hilscher NetLink driver provides Simatic MPI communication to Siemens devices via the Hilscher ‘NetLink’ Ethernet interface. This driver was designed specifically for the use with Siemens S7 300 and 400 and VIPA System 200V, 300V, 300S and 500S series.
Before the Netlink device can be used, an appropriate system configuration must be set. In particular you have to specify a valid IP address for the Netlink device. For further details please refer to “Netlink configuration” .
A single Hilscher NetLink driver can manage communication with a single Netlink device. This does not prevent from communicating with more PLCs at a time.
As an example, you can connect 3 PLCs with different MPI IDs through a standard Profibus cable, then connect the Netlink device to the MPI port of one of the PLCs and you will access all the 3 PLCs data areas.
The driver should be configured with 3 stations, each one with the specific MPI station ID of the related PLC, but all the stations must have the same IP address (server address), that is the IP address of the Netlink device as specified in “Netlink configuration” .
The use of more Netlink devices at a time is possible by duplicating the driver, that is creating a copy on the driver for each Netlink device in use. For further details see “Driver duplication” in the Supervisor manual.
Movicon 11 – Rel. 11.4.1.5 DBL286
Movicon 11 CE – Rel. 11.4.1.5 DBL286